How do i configure vtp

Optional clear vtp counters. Displays the VTP pruning eligibility of the trunk port. The default is that all the VLANs from 2 to are pruning eligible. VLANs to are reserved for token ring networks. This section includes the following sections:. Note Before Release 5. This example shows how to configure VTP in transparent mode for the device: switch config t switch config feature vtp switch config vtp domain accounting switch config vtp version 2 switch config vtp mode transparent switch config exit switch.

VTP Mode. VTP Domain. VTP Version. VTP Pruning. VTP per Interface. Specifies the name of the VTP domain that you want this device to join. The default is blank. Sets the VTP version that you want to use. The default is version 1. Sets the VTP mode to client, server, transparent, or off.

Specifies the password for the VTP administrative domain. Optional Displays information about the VTP configuration on the device, such as the version, mode, and revision number. Optional Displays information about VTP advertisement statistics on the device.

Optional Displays the list of VTP-enabled interfaces. After that we will configure trunking in our practice lab. This is the last part of this article. In this part we will provide a step by step guide to configure the VLAN. In our network we only have three switches. We can easily add or remove VLAN manually on all three switches. However this process could be more tedious and difficult if we have 50 switches.

In a large network, we might make a mistake in VLAN configuration. VTP is a life saver protocol in this situation. VTP messages can only be propagate through the trunk connections.

So we need to set up trunk connection between switches. This reduces the need to configure the same VLAN everywhere. Refer to Cisco Technical Tips Conventions for more information on document conventions. Note: Trunk negotiation does not work across VTP domains. All VTP Server switch es should have the same configuration revision number and it should also be the highest in the domain. This section provides some basic commands in order to configure VTP on the most commonly used Catalyst switches.

There are two methods that you can use in order to configure VTP, as this section shows.